Reducing back pain while
sitting in office chairs
Essential office chair advice
Sitting in office chairs for prolonged periods of time can definitely
cause low back pain or worsen an existing back or neck problem. This
is because sitting is a static posture that increases stress in the
back, neck, shoulders, arms and legs, and in particular, can add large
amounts of pressure to the back muscles and spinal discs. Moreover,
when sitting in an office chair for a long period, the natural
tendency for most people is to slouch over or slouch down in the
chair, and this posture can overstretch the spinal ligaments and
strain the discs and surrounding structures in the spine. Over time,
incorrect sitting posture and workplace ergonomics can damage spinal
structures and contribute to or exacerbate recurrent episodes of back
pain. This article outlines several guidelines for setting up one’s
office chair and workstation to help prevent back strain and promote
overall sound back health.
Top six guidelines
for office chairs
An ergonomic office chair is a tool that, when used properly, can help
one maximize back support and maintain good posture while sitting.
However, simply owning an ergonomic office chair is not enough—it is
also necessary to adjust the office chair to the proportions of the
individual’s body to improve comfort and reduce aggravation to the low
back and neck while sitting. Before adjusting an office chair, the
user should first establish the desired height of his or her desk or
workstation. This decision is determined primarily by the type of work
to be done and by whether the person using the chair is unusually
tall. The height of the workstation can vary greatly and will require
different positioning of the chair, or a different type of chair
altogether.
Once the workstation has been situated,
then the user can adjust the office chair according to his or her
physical proportions. Here are the most important
guidelines—distilled into a quick checklist—to help make sure that
your office chair and work area are as comfortable as possible and
will cause the least amount of stress to your spine:
-
Elbow measure
First, begin by sitting comfortably as close as
possible to your desk so that your upper arms are parallel to
your
spine. Rest your hands on your work surface (e.g. desktop,
computer keyboard). If your elbows are not at a 90-degree angle,
move your chair either up or down.
-
Thigh measure
Check that you can easily slide your fingers under your
thigh at the leading edge of the chair. If it is too tight, you
need to prop your feet up with an adjustable footrest. If you
are unusually tall and there is more than a finger width between
your thigh and the chair, you need to raise the desk/work
surface so that you can raise your chair.
-
Calf measure
With your bottom against the chair back, try to pass
your clenched fist between the back of your calf and the front
of your chair. If you can’t do that easily, the chair is too
deep. You will need to adjust the backrest forward, insert a low
back support (such as a lumbar support cushion, a pillow or
rolled up towel), or get a new office chair.
-
Low back
support
Your bottom should be pressed against the back of your
chair, and there should be a cushion that causes your lower back
to arch slightly so that you don’t slump forward or slouch down
in the chair as you tire. This low back support in the office
chair is essential to minimize the load (strain) on your back.
Never slump or slouch in the chair, as that places extra stress
on the structures in the low back, and in particular on the
lumbar discs.
-
Resting eye
level
Close your eyes while sitting comfortably with your
head facing forward. Slowly open your eyes. Your gaze should be
aimed at the center of your computer screen. If your computer
screen is higher or lower than your gaze, you need to either
raise or lower it to reduce neck strain.
-
Armrest
Adjust the armrest of the office chair so that it just
slightly lifts your arms at the shoulders. Use of an armrest on
your office chair is important to take some of the strain off
your neck and shoulders, and it should make you less likely to
slouch forward in your chair.
Avoid static
posture while sitting in office chairs
Finally, no matter how comfortable you are in your office chair,
prolonged, static posture is not good for your back and is a
common contributor to back problems and muscle strain. Try to
remember to stand, stretch and walk for at least a minute or two
every half hour. Even a quick stretch or some minimal movement –
such as walking to the water cooler or bathroom – will help. A
twenty minute walk will help even more, promoting healthy blood
flow that brings important nutrients to all the spinal structures.
In general, moving about and stretching on a regular basis
throughout the day will help keep your joints, ligaments, muscles
and tendons loose, which in turn will help you feel more
comfortable, more relaxed and more productive.
Alternatives to
a traditional office chair
While this article is about traditional office chairs, some people
prefer more active, ergonomic chairs, such as a Swedish kneeling
chair or a Swiss exercise ball. The Swopper, a dynamic stool
device, offers similar advantages. While traditional chairs are
designed to provide complete support, a kneeling chair (or Swedish
kneeling chair) promotes good posture without a back support, and
an exercise ball (or Swiss ball) helps develop your abdominal and
back muscles while you sit. Both of these alternatives require
more active use of one’s muscles (e.g. for balance and to sit
upright) than a traditional office chair. If you have an injured
back or other health problems, it is advisable to first talk with
your doctor prior to using one of these types of chairs.
There is not one type of office chair that
is optimal for all patients, and patients should determine their
individual preference for comfort while following the guidelines
explained in this article to promote good posture and back support
while sitting in an office chair.
|
Problem Solver If you have any questions regarding
this information please contact us e-mail:
panelking@aol.com
Phone: 800-286-5471
|